在线观看免费亚洲激情片,国产韩国欧美精品,精品一区二区三区四区日韩

Control Signal Lightning Protective Device

Update: 2013/10/12 View:

Brand: ANCEND
Type: AD-485
Price: RMB
Promotion: RMB ( 0 Customers Bought)

Introduction

Product Description

AD-485 Control Signal Lightning Protective Device is wildly used to protect the transmission of data of signal equipment such as telemetry signal and remote control signal equipment in computer communication system, surveillance control system, access control intercom system, PLC automatic control system, fire alarm system from lighting and surge, so it can avoid the damages caused by lightning induced voltage, network voltage fluctuation interference and electrostatic discharge.

Main features: AD-485 communicational signal surge protective series designed according to the standard of IEC surge protector. This product is standard screw fixing joint mode interface. It could protect 1-2 group circuit multiple rated voltage selection. It is easy to install and maintain. It adopts three-level tandem type, nominal discharge current series control signal lightning protective device can reach 5KA when sensitive communication special line was used. Response time is on the order of picosecond. It can protect the equipment adopting the newest semiconductor device.

Product Parameters

Continuous operation voltage	5V	12V	24V
Class discharge current (8/20US)	5KA	5KA	5KA
Max discharge current (8/20US)	10KA	10KA	10KA
Limit voltage UP	15V	30V	45V
Date transmission rate VS	10mbps	10mbps	10mbps
Insertion loss AE	0.2db	0.2db	0.2db
Response time TA	1ns	1ns	1ns
Interface mode	Bayonet mode	Bayonet mode	Bayonet mode
Typical use	RS485 lightning protection	DC12V lightning protection	24V lightning protection
Protective mode	Line to line, line to ground
Failure mode	Communication circuit line-to-ground short circuit or off position
Product standard	54MM25MM25MM
Test standard	IEC61643-21:2000

Security system: telemetry circuit, remote control circuit, communication circuit.

Industry control system: telemetry circuit, remote control circuit, communication circuit.

Fire extinguisher system: telemetry circuit, remote control circuit, communication circuit.

Other control system: telemetry circuit, remote control circuit, communication circuit

Installation and Service

1.Control Signal Lightning Protective Device is in series between signal path and the equipment which is protected with connection of 1.2 to 2 mode.

2. Input end of Control Signal Lightning Protective Device should be connected to signal path and output should be connected to the equipment which is protected. Do not connect the wrong end.

3. Performance will be affect if PE line of Control Signal Lightning Protective Device does not connect to equipotential bounding.

4. This product doesn’t need specific maintenance. Make sure that the device is near to the equipment, the closer the better. When the work system failure, please remove the device and check that if the system work well without the Control Signal Lightning Protective Device, if it work normally, it means that the device should be changed.

More Products

IR Intelligent middle s

IR Intelligent high spe